Pneumatic Valve 4V430-15 With Efficient Performance

Pneumatic Valve 4V430-15 With Efficient Performance

Solenoid valves are automated basic components used to control fluids and are actuators; they are not limited to pneumatics. The Solenoid Valve is used to control the flow direction of the compressed gas. The mechanical mechanism of the factory is generally controlled by a Pneumatic Cylinder.

Drawings

Application in Machine

Instructions of 4V Pneumatic Solenoid Valve:
1. check the components before use, whether they are damaged during transportation, then install and use them.
2. when installing, please pay attention to the direction of gas flow and whether the nozzle is correct.
3. Installation, pay special attention to whether the voltage meets the requirements, the whole machine debugging, it is recommended to use manual device debugging, and then power-on debugging.
4. please pay attention to dust prevention and suggest installing muffler at the exhaust port.
5.When connecting the pipeline, pay attention to the winding of the stop strip not to exceed the tooth end surface, and pay attention to the elimination of pipe joints, metal particles in the pipe, dust and oil pollution.

The following points for installation of solenoid valve are as follows:
1, installation should pay attention to the arrow on the valve body should be consistent with the media flow direction. Do not install in places where there is direct drip or splash. Solenoid valves should be installed vertically.
2, solenoid valves should be guaranteed to operate normally within the 15%-10% range of the rated voltage.
3. After installing the solenoid valve, there should be no reverse pressure difference in the pipeline. It needs to be energized several times to make it warm enough to be put into operation.
4. Solenoid valve should be thoroughly cleaned before installation. The medium should be free of impurities. Filter before valve.
5, when the solenoid valve malfunctions or cleaning, to ensure that the system continues to operate, it should install byp