2W200-20 Direct-acting NC Solenoid Valve
This is Operated NC G3/4'' Female Thread Solenoid Valve AC 220V Two Position Two Way.
Water Solenoid Valve is suitable for water or liquid as the working medium, can automatically control or remote control of water, oil, liquid and other working medium pipeline on and off.
Used to Control Automatically The Liquid and Gas in The Pipeline.
2W200-20:
2W: 2 Position 2 Way
200: Aperture of Flow Rate is 20 mm
20: 3/4'' inch
The Features and Specifications of 2W200-20 Solenoid Valve:
Model No. : 2W200-20 Motion Pattern : Direct Drive
Type : Normal Close Type
Joint Pipe Bore : G3/4'' Female Thread
Two position two way, normal close switch, magnetic solenoid valve.
The Technical Data of 2/2 way 3/4'' inch Solenoid Valve 2W200-20:
| Model No. | 2W200-20 |
| Working Medium | Air, Water, Oil, Gas |
| Motion Pattern | Direct Drive |
| Aperture of Flow Rate | 20 mm |
| CV | 7.6 m³/h |
| Joint Pipe Bore | 3/4'' |
Working-pressure
| Oil : 0~5kgf/cm³ Gas : 0~7kgf/cm³ Water : 0~5kgf/cm³ Air : 0~7kgf/cm³
|
Operating Temperature Range
| -5~80℃ |
| Voltage Range | +-10% |
| Material of Seal | NBR, EPDM or VITON |
2W0200-20 Normal Closed Solenoid Valve dimension Drawing
| Model | 2W200-20 |
| A | 107
|
| B | 57
|
| C | 123.5
|
| D | 73
|
| K(PT) | 3/4''
|
Deconstruction diagram of 2W200-20 Solenoid Valve:
The Detail image of AC 220V Brass Body Solenoid Valve 2W200-20:
Installation of 2W200-20 Direct-acting NC Solenoid Valve:
1.Before using the Solenoid Valve For Water, pay attention to the product label and read the instruction manual carefully to judge whether the product meets the conditions of use.
2.In order to avoid orifice obstruction, it is recommended to install a pre-filter.
3.There is an arrow indicating the direction of flow on the stainless valve body. Coil up is the preferred mounting direction but if necessary it can be installed in any position.
4.Stainless steel is present as the internal components and Viton as the seal material.
5.This Solenoid Valve is unidirectional .The installation should follow the instructions of “→”.
6.The Body Material is Brass. The Seal Material is NBR,EPDM or VITON.
7. When the solenoid valve is faulty, in order to isolate the solenoid valve in time and ensure the normal operation of the system, it is better to install a bypass device.
Welcome to your inquiry!
Contact Now
