1-1/2'' Goyen Type CA45FS Pulse Jet Solenoid Valve
The baghouse dust cleaning device is a system. The pulse jet solenoid valve releases the cleaned air source, which also needs to be transported through the blow tube and distributed to each filter bag. The airflow from the nozzle hole in the spray pipe causes the pressure in the filter bag to rise rapidly and shakes the filter bag, so that the dust collected on the dust-collecting surface of the filter bag can be peeled off, and a good combination of various factors can achieve good results.
Factors affecting the sensitivity of the Pulse Jet Valve switch include solenoid coil power, diaphragm mass, spring elasticity, orifice size, and valve cavity volume. The high sensitivity of the valve response to the electrical signal indicates that the valve has high mechanical coordination during the response to the electrical signal, the valve body component is relatively good in quality, and the cavity structure is relatively reasonable.
Overall dimension of 1 1/2'' CA45FS Goyen Type Pulse Jet Valve:
Details display of CA45FS Dust Collector Diaphragm Pulse Valve:
Technical parameters of FS series Goyen Replacement Pulse Valve:
| Model | | |
| Working Pressure | |
| Working Temperature | |
| Voltage | AC24V, AC110V, AC220V, DC24V |
| Inlet and Out Pipe Size | | |
| Remote or Integral | |
| Connection Type | |
| Body Material | |
| Diaphragm Material | NBR(Common), Viton(Available) |
Pulse Jet Bag Filter Working With Pulse Jet Solenoid Valve:
Dust collector with pulse jet valve:
The dust removal efficiency of bag filter can reach more than 99%, which can meet the environmental protection requirements; it can also better adapt to the fluctuation of exhaust air volume; it has more economic value when recovering valuable fine grain materials, but the initial investment is higher. Bag type dust collectors are often used in the purification of dusty flue gas or powdery materials in furnaces. It is mostly used for gas purification in metallurgy, cement, chemical, light industry and other industries, and is not limited by air volume.
Maintenance of dust collector:
1. The wind-locking device of the dust collector must ensure that the lock air is effective and the material is smoothly discharged. If the lock air is invalid, the negative pressure will be seriously lost in the return ash port, resulting in poor dust collection effect. Material, when the dust is severe, it will be filled with the inside of the dust collector, causing the dust to fail.
2. The pulse valve inspection of the dust collector ensures flexible and effective action. If there is air leakage, the diaphragm and internal corresponding parts (such as: valve core, spring, orifice) should be replaced. If the pulse valve fails, the blowing effect will be poor. The surface area of the filter bag cannot be removed to reduce the dust collection capacity.
3. Check the lifting cylinder of the dust collector to ensure that the lifting cylinder moves smoothly and ensure that the cylinder gland is tightened and not loose. Otherwise, the gland pressure will not be tight and can not be lifted; if the pressure is not tight, it will cause the cleaning to be cleaned. If it cannot be lifted, the corresponding air chamber cannot be collected.
4. The electromagnetic two-way five-way reversing valve inspection, to ensure smooth operation, no air leakage, no dust inside, otherwise it will cause the failure of the lifting cylinder.
Focus on your demands, Offer you best solution:
√ Contact us if some points you have doubt
√ Contact us if somewhere need to change
√ Contact us if not the one you are looking for
√ Contact us if you are doing designing
Welcome to your any question and inquiry!
Contact Now
