2 1/2'' AC220V DMF-Z-62S SBFEC Type Solenoid Valve

2 1/2'' AC220V DMF-Z-62S SBFEC Type Solenoid Valve

2-1/2'' Inch DMF-Z-62S Dust Collector Pulse Jet Valve we provide is an automation component in the dust suppression system, which improves the purification and blowing efficiency, and has a long service life and one year of product quality assurance. How to properly use the opening of the Pulse Jet Valve to control valve opening and time, which has a direct relationship to the life of the bag filter. The left knob of the Pulse Controller controls the opening degree of the blow solenoid valve. The left turn is small and the right turn is large. The right knob controls the pulse backflush time. The left turn is short and the right turn is long. Generally, it is adjusted to about one minute. Usually, the positions of the two knobs are set at about 450 right-handed.

Overall dimension of 2 1/2'' DMF-Z-62S SBFEC Type Pulse Jet Valve:

Details pictures of 2 1/2 Inch SBFEC Type DMF-Z-62S Solenoid Valve:

Technical parmaters of SBFEC Replacement Right Angle Diaphragm Valves:

Tips: All related accessories are also sold, like Pulse Controller, Diaphragm, Solenoid Coil and Armature Assembly.

Characteristics of pulse Jet Valve:
1. The working pressure of the product is 0.1MPa~0.8MPa, and the medium is clean air after degreasing and dewatering treatment.
2. Under the condition of product nominal air source pressure, when the working voltage of electromagnetic pulse valve is 85% of rated voltage, the opening response time of electromagnetic pulse valve should be less than 0.03s.
3. When the working air source pressure is 0.1MPa, the pulse valve can be closed.
4. The product should be able to withstand a gas source pressure of 0.8 MPa.
5. Under the specified environmental conditions, the insulation resistance of the electromagnetic coil to the outer casing should be greater than 1 MΩ.
6. At room temperature of 5 degrees to 35 degrees, and the relative humidity does not exceed 85%, the electromagnetic coil can withstand 50Hz, 250V voltage for the outer casing, and there is no breakdown phenomenon for 1min.
7. The electromagnetic pulse valve should work normally after being subjected to vibration with a frequency of 20 Hz, a full amplitude of 2 mm and a duration of 30 minutes.
8. Under normal conditions of use, the cumulative service life of the diaphragm should be greater than 1 million times.
9. The appearance of the valve has no obvious coating peeling, scratches, burrs and other damage.

Focus on your demands, Offer you best solution:

√ Contact us if some points you have doubt

√ Contact us if somewhere need to change
√ Contact us if not the one you are looking for

√ Contact us if you are doing designing

Welcome to your any question and inquiry!